1

The soldering gun did not provide very much heat.

2

I cut out a sheet of .090 aluminum. This will be mounted at an angle to clear the exhaust. Yes it will be all sealed up. The Electromotive TEC3 will be mounted here, along with the TCU and the power circuit fuse boxes. Maybe some 10,000 watt amps for the 20" woofers. haha. Do I look 16?

3

And the snow begins

4

Hmmm.

5

Some may remember this panel from the first Krylon Special Lite back in 2002. I drilled 4 holes for the smaller gauges. I also need to get a fuel level gauge and a speedo.

6

This is what it should look like. The gauges are just mocked up there. They are not mounted yet.

7

This is where the electronic speedo from Cyberdyne will be mounted. For mock up purposes I used a A/F ratio gauge.

8

I installed a defroster button where the blank was. This will be used to turn on the data logging on the TEC3.

9

Here is the rear defroster button. This will make the defroster work.